Tapered lighting pole for TpLuna, made of galvanized and painted steel.
The pole consists of tapered sections with a base diameter of 89 mm and a top diameter of 76 mm.
The base of the pole is equipped with an access door and a Class II terminal block.
At the top of the pole is a TPLX1 pole head for Luna-type lamps, made from a 40x25 mm tubular profile, shaped as per the drawing.
At the upper end, the tubular section is welded at a 90° angle to another tubular section (40x25mm) and finished with a 180° steel circle measuring 30x5mm.
At the end of the circle, there are holes for mounting the lamp.
In the center of the circle, connected to the tubular section, is a hole for cable routing.
The pole head is designed for mounting on 76 mm diameter poles and is secured to the pole with stainless steel grub screws.
Light source: "Signora" lamp, code 628.3H3K, light point height of 4 m.
All cables from the light source to the terminal block are routed and protected inside the pole structure.
A protective heat-shrink sheath is applied at the base of the pole where it meets ground level.
Foundation-mounted, embedded 800 mm below ground level.
The embedded section of the pole features a slot for cable passage to the junction box and a hole at ground level for earthing.
SURFACE PROTECTION
Cast iron surfaces are thoroughly sandblasted before the painting process.
Steel surfaces are galvanized.
The painting process is as follows:
one coat of single-component zinc phosphate primer, followed by a finishing coat of highly protective two-component catalyzed paint.
Standard color: antique black (EUROCOMITALIA type).
Custom RAL colors are available upon request.
HARDWARE
Stainless steel screws and accessories.
Components
TPLX1
RS3 3-Meter HFT Tapered Steel Pole
Surface protection
GENERAL INFORMATION ON SURFACE PROTECTION
All products undergo surface treatment and painting cycles calibrated according to the constituent material, product type, and final intended use.
Cast iron and aluminum surfaces are duly prepared by mechanical sandblasting or chemical pretreatment to ensure proper adhesion and protection of the coating.
Steel surfaces are protected by anti-corrosion treatments appropriate for the product's geometry and installation environment.
The coating is applied using a 5P cycle (thermosetting powder coating with electrostatic application) or a 3P cycle (spray painting with anti-corrosion primer and finish), depending on the substrate and performance requirements.
Standard finish: antique black, Eurocomitalia type.
Any color from the RAL Classic chart is available upon request.
Detailed technical specifications are available in the dedicated documentation.
Assembly instructions
GENERAL ASSEMBLY INSTRUCTIONS
All products are accompanied by specific assembly instructions for the model provided.
Each product, based on its nature and intended use, requires dedicated installation methods.
For detailed technical specifications, please refer to the dedicated documentation.
Screw protection
SCREWS AND BOLTS
All screws, bolts, and other fastening accessories are generally supplied in stainless steel.
DISCLAIMER
The data reported in the product sheets are the official data available at the time of publication and may be subject to change following technical updates made to the products.
The products may exhibit dimensional tolerances resulting from manufacturing processes, with a maximum deviation of 10% from the declared values.
EUROCOMITALIA reserves the right to make changes without prior notice and disclaims all liability for the accuracy and completeness of the content provided.